1) Plug the adapter into a setting socket.
2) Insert the setting shank into the adapter.
Note: Setting shank must match the
shank diameter and square of the tap adapter.
3) Lock the setting socket square into a vise.
4) Insert the opposite end of the setting shank into the torque wrench.
5) Remove wire locking ring.
6) Test the adapters torque by turning the wrench 3 full revolutions.
7) Use the spanner wrench and turn the adapters adjusting face to increase or decrease the
torque.
8) Once desired torque is reached replace the wire locking ring.
The adapter is ready for use.
Universal Engineering / DeVlieg® Tooling Systems / Tool Preset Service & Calibration
Last updated 02/10/2007