Vehicle Driveline Application Contact InformationName* Company* Phone*Email* Vehicle DataType of Vehicle Manufacturer Military use Yes No Partial Military Uses Driveline Rear WD Front WD 4x2 6x2 8x2 All WD Optional 4x4 6x6 8x8 10x10 Permanent Other Driveline Layout Engine Capacity(ccm)Max. Engine Output(kW)Max. Engine Output(RPM)Max. Torque(Nm)Max. Torque(RPM)Total (Loaded) Weight(kg)Curb Weight(kg)Weight Distribution: Front Axle(s)(kg)Weight Distribution: Rear Axle(s)(kg)Required Life(km)Rolling Radius of Wheels(mm)Size of TiresMax Vehicle Speed(km/h)Height of Center of Gravity(mm)Wheelbase(mm)Four Wheel Drive ApplicationsTorque Distribution: Front(%)Torque Distribution: Rear(%)If 4WD Not Permanent(axle)If 4WD Not Permanent: Time Share(%)If 4WD Not Permanent(axle)If 4WD Not Permanent: Time Share(%)Gear Rations / Duty CycleGear ratios/Duty cycleSpeedRatioTime Share %Comments on Operating Parameters Notes Limited Slip Differentials: Front Axle(%)Limited Slip Differentials: Rear Axle(%)Propshaft(%)Axle Differential RatioWheel Gear RatioConverter (Stall Ratio)T-Case RatioBrakes Inboard Outboard Front Half Shaft Bending AnglesWheel Position (mm)DescriptionInner AngleOuter AngleComments on Operating Parameters Notes Rear Half Shaft Bending AnglesWheel Position (mm)DescriptionInner AngleOuter AngleComments on Operating Parameters Notes Prop Shaft Bending Angles(Please Provide Detailed Side and Top View with all Position Identified in X, Y, Z Plane)PositionCompound Angle 1st JointCompound Angle 2nd JointInstalled LengthComments on Operating Parameters Notes Axial Slip / Length CompensationDuring Operation: Required axial slip for assembly/disassembly:(mm)Environmental ConditionsMax. Temperature(°C)Max. Continuous Temperature(°C)Min. Temperature(°C)Please describe how above temperatures occur (humidity conditions, radiation heat, exhaust etc.)Are there special environmental conditions? Please describe. Other SpecificationsPlease specify the type of required connections of the joints to the adjacent components (flange, stub etc.)Available space, envelope curve, please encloses sketches showing the available space for installation. Please state on all special requirements important for manufacturing (painting/ coating, Unbalance specs etc.)